Crăciun
Comandă înainte de 18 dec.  -  Informații suplimentare
×
Meniu

Alpinist U-Bow

(10)
1 pereche
Nr.
1 pereche
2 perechi
3 perechi
4 perechi
Cantiate limitată disponibilă
Nr.
1 pereche
2 perechi
3 perechi
4 perechi
5 perechi
6 perechi
7 perechi
8 perechi
9 perechi
10+
Adaugă în coș
  Salvează pentru mai târziu
Livrare 3 zile lucrătoare
365 de zile pentru retur

Descriere

Accesoriu Marker Alpinist U-Bow pentru legăturile Alpinist pin tech.

Alegeți această piesă de toc în diferite rigidități.

  • Soft = Aproximativ 5,5DIN
  • Medium = Aproximativ 8DIN
  • Hard = Aproximativ 11DIN

Specificațiile acestui model

Model Greutate
Medium35g
Hard40g

Specificații

Utilizare Optimă:
Touring
Afișează toate

Recenzii   (10)

Cumpărător verificat
"Quick delivery from the US to Canada and exactly as ordered. Flawless shopping experience! My tip to install, use a fairly big set of those quick adjust pipe wrench that opens to 2” gap or so. Just press them into position and use them to get the old ones half way out. Easy peezy."
Flavelle Scott (Mount Currie) 27/01/2021
Cumpărător verificat
"The Marker U springs arrived faster than expected, and are exactly as advertised."
Kenneth Linden (Irvine) 19/01/2021
Cumpărător verificat
"Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again."
Archie Gillies (Aberdeen) 12/11/2020
Cumpărător verificat
"Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them."
Karol S. (Northport) 28/10/2019
Afișează toate 10 recenziile
SkatePro